Check Point 61000 Manual de servicio descargar pdf (Pagina 37)

Showing Chassis and Component Status (asg monitor)

Monitoring and Configuration Commands Page 37

 If you run asg stat -v, the output shows a higher unit weight and Chassis Grade:

Failure of an SGM with this high unit weight will cause a chassis failover, as the minimum grade

gap for chassis failover remained at 11.

 Minimum threshold for traffic processing

The minimum grade required for the chassis to become ACTIVE.

Minimum grade gap for chassis failover

Minimum grade gap is a value that determines when a chassis fails over. If the active chassis grade

drops by the "minimum grade gap" failover may occur. The active chassis is always the chassis whose

grade is higher by at least the minimum grade gap.

 Synchronization

Within chassis

Whether synchronization is enabled between SGMs in the same

chassis

Between chassis

Whether synchronization is enabled between SGMs in different chassis

Exception Rules

Whether the user has configured any synchronization exception rules

using the asg_sync_manager commands

Distribution

Control blade

Whether the control blade feature is enabled. The control blade feature

sets the SMO not to handle data traffic, only management traffic. When

the feature is enabled, you always have immediate access to the

system through an SSH connection.

Showing Chassis and Component Status

(asg monitor)

Description

Use this command to show the chassis and component state for single chassis

and dual chassis configurations.

Syntax

asg monitor [interval][-v [interval]][-all interval]

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 46 47

Sin comentarios

Check Point 61000 Manual de servicio Pagina 37