Check Point 61000 Manual de servicio descargar pdf (Pagina 26)

Inserting Front Blank Panels

Step 3: Installing Components and Connecting Power Cables Page 26

Inserting QSFP Splitters

1. Insert the QSFP transceiver into the Security Switch Module.

2. Insert the QSFP splitter cable into the transceiver.

This converts the 40GbE QSPF port to 4 10GbE ports.

Inserting Front Blank Panels

Blank panels contain cooled air in the appliance. Use the blank panels to close open slots.

To Insert a blank Panel at the front:

1. Insert the blank panel into the open slot.

2. Tighten the two tumble screws.

Note - Rear blank panels are pre-installed on the chassis.

Connecting a Second Chassis

If you have a dual chassis environment (for chassis high availability):

 For the second chassis, repeat steps 1-3

 Connect the second chassis

 On each SSM, connect the sync ports to the same sync ports on the backup chassis.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 46 47

Sin comentarios

Check Point 61000 Manual de servicio Pagina 26